Transport and storage | Automax 100 | Basic module TS-AC B1-M2-1X
Transport and storage
6.1
Transporting the product
Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
Chapter
„Safety
instructions" as of page [7] in these operating instructions must
always be observed!
Risk of injury, potential property damage during transport due to improper handling!
Risk of injury, property damage
Do not walk or stand under suspended loads
Always lift or carry the basic module separately
Wear safety shoes
For transport of the basic module TS-AC B1-M2-1X, observe its protection class of IP20
according to DIN EN 60529.
Protection class IP20 means:
2 – protected against ingress of foreign particles >12.5 mm diameter
0 – not protected against ingress of water (humidity)
Prevent increased vibrations and shocks during transport and transport the product inside a
packaging that protects it against dust and humidity.
6.2
Storing the product
Risk of damage caused by humidity and dampness!
Damage to property
Protect the basic module from humidity by means of covers
Storage only in rain-protected, dry rooms
Protect the basic module against strong temperature variations, strong solar radiation
and cooling in order to prevent the formation of condensation water and corrosion
The basic module TS-AC B1-M2-1X must be stored in a dry, dust-protected and vibration-
free environment and protected from light and direct sunlight.
Storage specifications for basic module TS-AC B1-M2-1X
Designation
Storage temperature range
Relative air humidity
No condensation
No ice formation/icing
DANGER
WARNING
NOTICE
Bosch Rexroth AG | 04.2021 | DOK-SUPPL*-TS-AC B1-M2-ITRS-EN-P
23/54
Unit
Value
℃
-25 to +70
%
max. 90
---
---
---
---