Sony WALKMAN MZ-R909 Operating Instructions Manual page 91

Recorded Same as the
sound level source.
You can also
adjust it
manually
(Digital REC
level
control).
1) When the sound source is a CD or an MD.
2) With a sound source other than a CD or an MD.
3) The recorder pauses automatically when it
encounters a section with no audio signal for 3
seconds or more.
Notes
Track marks may be copied incorrectly:
• when you record from some CD players or
multi disc players using digital (optical)
input.
• when the source is in shuffle or program
play mode while recording using digital
(optical) input. In this case, play the source
in normal play mode.
• when recording BS or CS programs through
digital (optical) input.
Recording with analog input
(line cable required)
See the illustration in Japanese text (page 25).
The sound will sent from the connected
equipment as analog signal but will be
recorded digitally on the disc.
1 Connect the LINE IN (OPT) jack of the
recorder to the line output jack of the
source with an line cable (not supplied).
The recorder switches to analog input
automatically.
2 Connect the power source.
To use on AC power, see "Recording an
MD right away!." To use on other power
sources, see page 88.
3 Press and slide REC to the right.
"REC" and the REC indicator lights up
and recording starts.
4 Play the sound source.
Note
If you temporarily stop a recording operation
by pressing X, a new track mark will be
added at that point where you pressed X
again to resume recording. The recording
continues from a new track.
Adjusted
automatically.
You can also
adjust it
manually.
Recording for long times
See the illustration in Japanese text (page 26).
Select each recording mode according to
the recording time that you want.
Stereo recording is possible at 2 times (LP2)
or 4 times (LP4) the normal recording time
(MDLP mode).
1 Press the jog dial, turn the dial until
"REC MODE" flashes in the display, and
then press the dial again.
2 Turn the jog dial to select the desired
recording mode.
The recording mode can be selected
from "(none)"(standard stereo mode),
"LP2" (2 × normal recording mode),
"LP4" (4 × normal recording mode), and
"MONO" (monaural).
3 Press and slide REC to the right.
Recording starts.
4 Start the sound source.
When you do not want "LP:"
added at the beginning of the
track
The recorder is factory set to add "LP:" at
the beginning of tracks recorded in MDLP
mode. If you do not want "LP:" to be
added , do the procedure below.
1 While the recorder is stopped, press the
jog dial, turn the dial until "OPTION"
flashes in the display, and then press the
dial again.
2 Turn the jog dial util "LP Stamp" flashes
in the display, and then press the jog
dial.
3 Turn the jog dial until "Stamp OFF"
flashes in the display, and then press the
jog dial.
If you want "LP:" added, select "Stamp
ON" in step 3, and then press the jog
dial.
Notes
• It is recommended that you use the supplied
AC power adaptor for long recordings.
Continued
91