Sony WALKMAN MZ-R909 Operating Instructions Manual page 90

1)
You can turn off the beep sound.
2) If you press . during the first track of the
disc, the recorder goes to the beginning of
the last track on the disc.
3)
If you press > during the last track of the
disc, the recorder goes to the beginning of
the first track on the disc.
4) Once you open the lid, the point to start play
will change to the beginning of the first track
(except when the disc information has been
stored in the Personal Disc Memory).
If the playback does not start
Make sure the recorder is not locked. If it is
locked, slide the HOLD switch in the opposite
direction of the arrow.
When using the headphones/
earphones connect them directly
to the recorder
The VOL +/– buttons and the Digital Sound
Preset function may become inoperative. In
this case, do the procedure below.
1 Press the jog dial, turn the dial until
"AUDIO OUT" flashes in the display,
and then press the dial again.
2 Turn the jog dial until "HeadPhone"
appears in the display.
3 Press the jog dial again.
Note
If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) when
the recorder is operating, the lid will not open
until the power is restored.
90
BVarious ways of
recording
Connecting digital (optical)
and analog (line) inputs
The recorder selects digital or analog input
according to how the sound source is
hooked up.
Input Digital
(optical)
input
Difference
Connectable Equipment
source with an
digital
(optical)
output jack
Usable cord Optical cable
(with an
optical or an
optical-mini
plug)
Signal from
Digital
the source
Recorded Marked
track (copied)
numbers automatically
•at the same
positions as
the source
•after more
than 2
seconds of
blank or
low-level
segment
•when
recording is
paused
while
synchro-
recording
Analog (line)
input
Equipment
with an analog
(line) output
jack
Line cable
(with 2 phono
plugs or a
stereo-mini
plug)
Analog
Even when a
digital source
(such as a CD)
is connected,
the signal sent
to the recorder
is analog.
Marked
•after more
than 2 seconds
of blank or low
level segment.
1)
. •while the
recorder is
paused while
recording.
•automatically
at specified
2)
. intervals when
the Auto time
stamp is on.
You can erase
unnecessary
marks after
3)
. recording.