Sony WALKMAN MZ-R909 Operating Instructions Manual page 89

Hide thumbs Also See for WALKMAN MZ-R909:
Table of Contents

Advertisement

Notes
• "Data Save" or "TOC Edit" flashes while
data of the recording (the track's start and
end points, etc.) is being recorded. Do not
move or jog the recorder or disconnect the
power source while the indication is flashing
in the display.
• The lid does not open until "TOC Edit"
disappears in the display.
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected)
during a recording or editing operation, or
while "TOC Edit" appears in the display,
then it will not be possible to open the lid
until power is restored.
• You can make a digital recording only from
an optical type output.
• When recording from a portable CD player,
set the CD player to pause, and then do the
recording procedure on the recorder.
• Note the following when recording from a
portable CD player:
— Some portable CD players may not be
capable of digital out unless powered by
the AC power. If this is the case, connect
the AC power adaptor to the portable
CD player and use it on AC power as the
power source.
— On some portable CD players, optical
output may not be possible when using
an anti-skip function (e.g., ESP*). If this
is the case, turn off the anti-skip
function.
* Electronic Shock Protection
BMD playing
Playing an MD right away!
See the illustration in Japanese text (page 22).
If you want to use the rechargeable battery,
be sure to recharge them before playing
(page 87).
1 Start playing.
1 Press N. Turn the control towards
N> on the remote control.
A short beep sounds in the
headphones/earphones.
2 Press VOL +/– on the recorder to
adjust the volume. Pull and turn the
control towards VOL + or towards
VOL – on the remote control.
Playback starts from the point you last
stopped playing. To start playback from
the beginning of the disc, press N for 2
seconds or more on the recorder, or turn
and hold the control towards N> for 2
seconds or more on the remote control.
To stop play, press x.
To
Do this (Beeps in the
headphones/earphones
Find the
Press .. Turn the
beginning of the
control towards . on
current track
2)
the remote control.
(Three short beeps)
Find the
Press >. Turn the
beginning of the
control towards N>
3)
next track
on the remote control.
(Two short beeps)
Go backwards
Keep pressing ..
while playing
Turn and hold the
control towards . on
the remote control.
Go forward
Keep pressing >. Turn
while playing
and hold the control
towards N> on the
remote control.
Pause
Press X. (Continuous
short beeps) Press X
again to resume play.
Remove the MD Press x, then slide
OPEN to open the lid.
1)
)
4)
89
Continued

Advertisement

Table of Contents
loading

Table of Contents