Sony WALKMAN MZ-R909 Operating Instructions Manual page 88

BMD recording
Recording an MD right away!
See the illustrations in Japanese text (pages 19
and 20).
Connect to a digital source using an optical
cable to make digital recordings. Digital
recording is possible even from digital
equipment with different sampling rates,
such as a DAT deck or a BS turner, using
the built-in sampling rates converter. To
record from an analog source, see
"Recording with analog input (line cable
required)." To record a track into an
existing group, see "Recording tracks using
the group function" (page 92). It is
recommended to use the supplied the AC
power adaptor when recording.
1 Make connections. (Insert the cables
firmly and completely into the
appropriate jacks.)
1 Connect the LINE IN (OPT) jack of
recorder to the DIGITAL OUT jacks
of the source with a optical cable.
The recorder switches to analog input
automatically.
2 Connect the DC IN 3V jack of the
recorder to a wall outlet with the
supplied AC power adaptor.
When the recorder has different sound
sources connected at the same time, the
recorder switches to the digital,
microphone, or analog input in this
order of priority.
2 Specifying the recording position.
Set the "REC-Posi" setting to "From
End" (recording starts from the end of
the current contents) or "From Here"
(recording starts overwritting the
current contents).
3 Start recording.
1 Press and slide REC to the right.
"REC" lights up and recording starts .
2 Play the sound source.
The level of the recorded sound is
adjusted automatically.
88
To stop recording, press x.
After you press x to stop, the recorder will
automatically turn off in about 10 seconds
(when using batteries) or about 5 minutes
(when using AC power adaptor).
To Do this
Record from the Press END SEARCH
end of the current and then press and
contents 1) slide REC to the right.
Record over Press N, >, or .
partway through to find the start point of
the previous recording and press x
recording to stop. Then press and
slide REC to the right.
Pause X.
Press X again to
resume recording.
Remove the MD x, then slide OPEN to
open the lid.
1)
By setting "REC-Posi" to "From End,"
recording operations will always start from
the end of the previously recorded material.
2) A new track mark is added at the point
where you pressed again to resume
recording while pausing, and the recording
will be marked with the new track number
when you resume recording.
3) If you open the lid while "REC-Posi" is set
to "From Here", recording will begin with
the first track the next time you record, the
point to start recording will change to the
beginning of the first track. When recording
on a recorded MD, check the point to start
recording on the display.
If the recording does not start
• Make sure the recorder is not locked.
• Make sure the MD is not record-
protected.
• Premastered MDs cannot be recorded
over.
2)
3)