Sony WALKMAN MZ-R909 Operating Instructions Manual page 113

When playing (JEITA
Batteries Stereo
NH-14WM 24
nickel metal
hydride
rechatgeable
battery 4)
LR6 (SG) 34
alkaline dry
5)
batttery
NH-14WM 64
nickel metal
hydride
rechargeable
battery 4) + one
5)
LR6 (SG)
1) The battery life may be shorter due to
operating conditions and the temperature of
the location.
2) When you record, use a fully charged
rechargeable battery.
3)
Measured value by the standard of
JEITA(Japan Electronics and Information
Technology Industries Association).
4) When using a 100% fully charged
rechargeable battery.
5)
When using a Sony LR6 (SG) "STAMINA"
alkaline dry battery (produced in Japan).
When to replace the batteries
When the dry battery or rechargeable
battery are weak, flashing r or "LOW
BATT" appears in the display. Replace the
dry battery or charge the rechargeable
battery.
The battery level indicator is approximate.
It may be more or less than the indication
depending on the operating condition.
Note
Stop the recorder before replacing battery.
3)
)
(Unit: approx. hours)
LP2 LP4
27 31
40 45
75 84
BAdditional information
Messages
If the recorder cannot carry out an
operation, error messages may flash in the
display window as follows.
BANK FULL :
The phrase bank is almost full and
cannot store the phrase you tried to
enter.Delete some phrases from the
phrase bank, and then reenter the new
phrase.
BLANK DISC :
You tried to play an MD with no
recording on it.
BUSY :
You tried to operate the recorder while
it was accessing the recorded data.
Wait until the message goes out (in
rare cases, it may take a few minutes).
Data Save :
The MD recorder is recording
information (sounds) from the
memory to the disc. Wait until this
process is completed. Do not expose
the recorder to any physical shock, nor
disrupt power supply.
DISC ERR :
The recorder cannot read the MD (it is
scratched or dirty). Reinsert the MD. If
the same message still appears, replace
the MD.
DISC FULL :
There is no more space to record on
the MD.
EMPTY :
You tried to erase data in the phrase
bank but no data have been recorded.
Hi DC in :
The power supply is higher than
required. Use the recommended power
sources.
HOLD :
You tried to operate the recorder with
the HOLD switch slid in the direction
of the arrow. Slide back the switch.
113