Sony WALKMAN MZ-R909 Operating Instructions Manual page 114

LINE OUT :
You pressed VOL +/– while the
"AUDIO OUT" parameter is set to
"LINE OUT." Use the jog dial to set
the "AUDIO OUT" parameter to
"HeadPhone."
LOW BATT :
The rechargeable battery or dry battery
is weak. Charge the rechargeable
battery or replace the dry battery.
MEM OVER :
You started recording with the
recorder receiving continuous
vibration. Put the recorder on the
stable place and start recording again.
MENU :
You pressed a key on the remote
control while selecting a menu on the
recorder.
NAME FULL :
You tried to enter more than 200 letters
to label a single track or disc.
You tried to enter a total of more than
1700 letters for track or disc names.
NO BATT :
The rechargeable battery is not
inserted. Insert a rechargeable battery.
NO COPY :
You tried to make a copy from a disc
that is protected by the Serial Copy
Management System. You cannot
make copies from a digitally connected
source which was itself recorded using
the digital connection. Use the analog
connection instead.
NO DISC :
You tried to play or record with no
disc in the recorder.
No Entry! :
You tried to erase a setting in the
Personal Disc Memory on a disc that
contains no settings in the Personal
Disc Memory.
No Group:
You tried to turn the group function on
with a disc which has no group
information. Use a disc which the
group information has been recorded.
114
NO SIGNAL :
The recorder could not detect digital
input signals. Make sure that the
source is connected firmly. If the
message appears while recording,
press x to end recording.
NO TEXT
You tried to use the CD text copying
function to copy a track or disc name
from a CD that has no text data.
P/B ONLY :
You tried to record or edit on a
premastered MD (P/B stands for
playback).
PROTECTED :
You tried to record or edit on an MD
with its tab in the record-protect
position.
SORRY :
You tired to set Digital Sound Preset
while the "AUDIO OUT" parameter is
set to "LINE OUT." Use the jog dial to
set the "AUDIO OUT" parameter to
"HeadPhone."
You tried to erase a track mark while
playing the MD or at the beginning of
the first track.
You tried to erase a track mark to
combine tracks the recorder cannot
combine (a track recorded in different
recording mode such as in LP2 and
LP4, or a track recorded through
analog connection and digital
connection)*.
You tried to overwrite a track marrk.
You tried to press X, T MARK or REC
MODE while synchro-recording or the
joint text function is active.
* If you have recorded or erased many
times on the same MD, the data of a
single track may be scattered
throughout the MD. When the data is
scattered in groups of less than 12
seconds long, the recorder will not be
able to combine the tracks.
TEMP OVER :
Heat has built up in the recorder. Wait
until the recorder cools down.