Sony WALKMAN MZ-R909 Operating Instructions Manual page 107

Retrieving phrases
Note
Phrases stored in the name bank cannot be
retrieved by the procedure described in
"Searching for a phrase by displaying the
stored phrase one by one." To retrieve a
phrase from the name bank, follow the
procedure described in "Searching for a
phrase by its first letter."
Searching for a phrase by displaying the
stored phrase one by one
1 Do the procedure "On the remote
control" in "Labeling recordings" (page
104) until " :Name," "GP: Name," or
" :Name" appears in the display.
Then press x.
2 Press X repeatedly until the first phrase
stored in the recoder's memory appears
in the display.
3 Turn the control towards . or N>
repeatedly.
Turning the control causes the phrases
stored in the recoder's memory to
appear one by one.
4 Press x while the phrase you want is
shown in the display, and then press x
for 2 seconds or more.
The cursor flashes after the phrase you
just retrieved.
Searching by the first letter of a phrase
1 When labeling a track, group, or disc,
turn the control towards . or N>
to move the cursor to the letter which
the desired phrase begins with.
2 Press X to search so that the phrase
corresponding to that letter appears.
3 Turn the control towards N> until
the desired phrase flashes in the display.
Turning the control causes all the other
phrases stored in the name bank appear
one by one.
After all the phrases have appeared, the
characters in the character palette appear
in the display one by one.
4 Press x while the phrase you want is
shown in the display, and then press x
for 2 seconds or more.
The cursor flashes after the phrase you
just retrieved. You can then continue
with labeling operation.
Erasing phrases
1 Press DISPLAY for 2 seconds or more,
turn the control towards . or N>
until "EDIT" flashes in the display, and
then press x.
2 Turn the control towards . or N>
repeatedly until "BankErase" appears in
the display, and then press x.
3 Turn the control towards . or N>
repeatedly until the phrase you want to
erase appears, and then press x.
"Erase!" appears in the display and the
phrase is erased.
To cancel the operation
Press DISPLAY for 2 seconds or more.
Registering tracks or groups
as a new group (Group
setting)
See the illustrations in Japanese text (pages 60
and 61).
Do the following procedure to register
tracks (or groups). A series of tracks (or
groups) can be registered by selecting the
starting and ending tracks (or groups). The
tracks (or groups) must, however, be
sequential. If the desired tracks (or groups)
are not consecutive, you must move them
to make them consecutive before you can
register them ("Moving recorded tracks",
page 108). This function can be used at any
time, whether group mode is on or off.
1 While the recorder is stopped, press the
jog dial, turn the dial until "EDIT"
flashes in the display, and then press the
dial again.
2 Turn the jog dial until "
the display, and then press the jog dial.
"001" flashes in the display.
: Set" flashes in
Continued
107