Sony WALKMAN MZ-R909 Operating Instructions Manual page 105

5 Follow steps 5 to 7 of "Labeling a disc
during stop".
Labeling a track, a disc, or a group
during recording
To label a group, you must turn the group
mode on before the start of recording (page
92).
1 Press DISPLAY for 2 seconds or more
during recording.
2 Turn the control towards . or N>
until "EDIT" flashes in the display, and
then press x.
" : Name" flashes in the display.
3 To label a track, press x while "
Name" is flashing.
To label a group, turn the control
towards . or N> until " GP :
Name" flashes in the display, then press
x.
To label a disc, turn the control towards
. or N> until "
flashes in the display, then press x.
The track, group, or disc is ready to be
labeled.
4 Follow steps 5 to 7 of "Labeling a disc
during stop."
To cancel labeling
Press DISPLAY for 2 seconds or more.
Notes
• When the recording is stopped while
labeling a track, a group, or a disc during
recording, or when the playback moves on
to the next track while labeling a track
during playback, the input at that point is
entered automatically.
• "LP:" has automatically been added at the
beginning of the track names for tracks
recorded in MDLP mode.
Relabeling recordings
Follow the steps corresponding to the
labeling method until the track, group, or
disc is ready to be labeled. Enter a new
character over the one you want to change,
then press the jog dial for 2 seconds or
more (keep pressing x for 2 seconds or
more on the remote control).
Notes
• Track and disc titles that were entered in
• You cannot relabel premastered MDs or
• The recorder cannot rewrite a track, group,
Storing phrases frequently
used in labeling
:
See the illustrations in Japanese text (pages 57
and 59).
Phrases that you often use in track or disc
labeling can be stored in the recorder's
memory. Approximately 40 phrases of
about 10 characters each (with a total
character count of about 600) can be stored
: Name"
in the phrase bank. The actual number will
depend on the length of each phrases.
On the recorder
Storing phrases into the name
bank (Name Bank function)
1 Press the jog dial, turn the dial until
2 Turn the jog dial until "Name Bank"
3 Enter the phrase you want to store, and
Storing phrases while labeling a
track or disc
1 Do the procedure "On the recorder" in
2 After entering the phrase, press END
Japanese katakana characters will appear in
Roman letters on minidisc players that do
not support the display of katakana
characters. Such titles will be marked with a
"^" at the beginning and the end.
label MDs that have not been recorded.
or disc name of more than 200 letters that
was created by another device.
"EDIT" flashes in the display, and then
press the dial again.
flashes in the display, and then press the
dial.
then press the jog dial for 2 seconds or
more.
"Entry!" appears in the display and the
phrase is stored.
"Labeling recordings" (page 103) to
enter a phrase.
SEARCH for 2 seconds or more.
"Entry!" appears in the display and the
cursor flashes after the phrase you just
stored. You can then continue with
labeling operation.
105