Frame Assembly - KidKraft Summerhill F29050 Installation And Operating Instructions Manual

Step 4: Frame Assembly
Part 1
It is important to assemble the frame on a flat, smooth surface.
A: Place (2627) SW Wall Panel between 2 Front and Back Walls from Step 2, noticing the wall orientations.
The tops and bottoms of the walls should be flush. Make sure the walls are square then using the pilot holes
as a guide pre-drill with a 3/16" (4.8 mm) drill bit and fasten the Front Wall to the Swing Wall and Swing Wall to
the Back Wall with 4 (WL5) 1/4 x 2-1/2" Wafer Lags per side. (fig. 4.1, 4.2 and 4.3)
Fig. 4.1
Top View
Front Wall
Notice Front
Wall overlaps
Swing Wall
WL5
Flush
Fig. 4.2
Flush
Swing Wall
Notice counter sunk
holes on the outside
Wood Parts
1 x SW Wall Panel 31.8 x 1066.8 x 2209.8 mm
2627
2627
Swing Wall
Front Wall
Flush
Hardware
8 x
WL5
Back Wall
Notice Swing Wall
overlaps Back Wall
Flush
WL5
1/4 x 2-1/2" Wafer Lag
21
Fig. 4.3
Notice grooves
face inwards
Back Wall
WL5
x 4 per
side