Output Hold/Clear Setting Function - Mitsubishi NZ2GFCF-D62PD2 User Manual

8.17

Output HOLD/CLEAR Setting Function

When the high-speed counter module is disconnected from data link, or the CPU module operating status is STOP,
whether to hold or clear the last Coincidence output (EQU1 to EQU4) and the output status of the extension output
module can be set. Set whether to hold or clear the values for all the output points of the module in a batch from the
module parameter setting window of GX Works2 or the program.
(1) Output HOLD/CLEAR setting and its operation
The following table lists the ON/OFF status of when HOLD or CLEAR is set for an output.
Operating status
CPU module in RUN
CPU module in STOP
Data link in
operation
CPU module in PAUSE
CPU module in RESET
During disconnection/cyclic stop
(2) Setting method
1.
Set "Parameter write" for "Method selection".
"CC IE Field Configuration" window
2.
For "Output HOLD/CLEAR setting", select "0: CLEAR" or "1: HOLD".
Output HOLD/CLEAR setting
When the output status changes according to the change in the comparison result after the output is set to HOLD, the output
of the following functions changes.
• Coincidence output (EQU1 to EQU4) of the coincidence output function
• Coincidence output (EQU1 to EQU4) of the PWM output function
• Output of the extension output module that is used as the output of the cam switch function (Y0 to YF)
"Output HOLD/CLEAR setting"
"0: CLEAR" (default)
Last output
status OFF
OFF
OFF
OFF
OFF
OFF
[CC IE Field Configuration]
Item
"Output HOLD/CLEAR setting"
Last output
status ON
ON OFF
OFF OFF
ON OFF
OFF OFF
OFF OFF
Select a high-speed counter module in "List of stations"
[Parameter Processing of Slave Station]
• 0: CLEAR
• 1: HOLD
CHAPTER 8 FUNCTIONS
"1: HOLD"
Last output Last output
status OFF status ON
ON
ON
ON
ON
ON
Setting range
8
167