Mitsubishi NZ2GFCF-D62PD2 User Manual page 220

Error code
Classification
(hexadecimal)
673
Moderate error
H
810 Moderate error
H
811
Moderate error
H
218
Description and
Error name
cause
The value in CH Cycle
setting (PWM output)
(RWw20 to RWw21,
RWw38 to RWw39) is
CH ON smaller than the value in
width/Cycle CH ON width setting
setting error (PWM output) (RWw1E to
(PWM output) RWw1F, RWw36 to
RWw37).
 indicates the channel
where settings are
incorrect.
A value other than 0 to 4 is
set in CH Operation
mode setting (address:
CH Operation
0120 , 0140 ).
mode setting
H H
error
 indicates the channel
where settings are
incorrect.
The setting in CH Count
source selection (address:
0121 , 0141 ) is in either
H H
of the following cases.
• If the value in CH
Operation mode setting
(address: 0120
0140 ) is 0, a value
CH Count
H
source selection
other than 0 to 2 is set.
setting error
• If the value in CH
Operation mode setting
(address: 0120
0140 ) is 1 or 2, a value
H
other than 0 is set.
 indicates the channel
where settings are
incorrect.
Operation of when an error
occurs
Error CH
If CH PWM
output start
command
(RY26, RY3E) is
turned off then
*12
on:
If CH ON
*3
width setting
change request
(PWM output)
(RY35, RY4D) is
turned off then
*1
on:
*13
,
H
*13
,
H
Action
The other
CHs
Set the values that satisfy the
condition "CH ON width
setting (PWM output) (RWw1E
to RWw1F, RWw36 to RWw37)
≤ CH Cycle setting (PWM
output) (RWw20 to RWw21,
RWw38 to RWw39)", and
perform either of the following
operations.
• If CH PWM output (RX26,
RX3E) is off, turn off then on
CH PWM output start
command (RY26, RY3E).
• If CH PWM output (RX26,
RX3E) is on, turn off then on
CH ON width setting
change request (PWM
output) (RY35, RY4D).
Set CH Operation mode
setting (address: 0120
0140 ) to a value between 0
H
and 4, and turn off then on
Initial data setting request flag
(RY9).
Take either of the following
actions on CH Count source
selection (address: 0121
0141 ), and turn off then on
H
Initial data setting request flag
(RY9).
• If the value in CH
Operation mode setting
(address: 0120
set a value between 0 and 2.
• If the value in CH
Operation mode setting
(address: 0120
or 2, set 0.
,
H
,
H
, 0140 ) is 0,
H H
, 0140 ) is 1
H H