Table of Contents
Advertisement
6.5
Wiring of Ethernet Cable
(1) Connecting the Ethernet cable
(a) Connecting
CHAPTER 6 INSTALLATION AND WIRING
1.
Power off the power supplies of the high-speed
counter module and the external device.
2.
Push the Ethernet cable connector into the high-
speed counter module until it clicks. Pay attention
to the connector's direction.
3.
Power on the module.
4.
Power on the external device.
5.
Check that the LINK LED on the port into which the
Ethernet cable is connected is on. The LINK LED
may take a few seconds to turn on after power-on. If
the LINK LED does not turn on, refer to the
troubleshooting section and take a corrective
action. (
Page 224, Section 11.3)
6
65
Advertisement
Table of Contents
Troubleshooting
