Mitsubishi NZ2GFCF-D62PD2 User Manual page 199

(9) Program example under the normal mode (when the cam switch function is set
with the comparison output function)
(a) Common program
The program is the same as the program example of the normal mode. (
(b) Initial setting program
(c) Counter function programs
The program is the same as the program example of the normal mode. (
CHAPTER 9 PROGRAMMING
Page 193, Section 9.3 (8) (a))
Start remote buffer memory extended
parameter initial settings.
Cam switch function, step type
(Output 1)
Cam switch function, number of steps
(Output 1)
Cam switch function, step No.1 setting
(Output 1)
Cam switch function, step No.2 setting
(Output 1)
Cam switch function, step No.3 setting
(Output 1)
Cam switch function, step No.4 setting
(Output 1)
Cam switch function, step No.5 setting
(Output 1)
Cam switch function, step No.6 setting
(Output 1)
Write the extended parameters.
The extended parameter write is
normally completed.
Turn on Initial data setting request flag.
Turn off Initial data setting request flag.
Start a remote register initial setting.
CH1 Preset value setting
Set the value to the remote register.
Turn on Initial data processing
completion flag.
Turn off Initial data processing
completion flag.
Page 194, Section 9.3 (8) (c))
197
9