Lenovo ThinkSystem SR850 V2 Service Manual page 256

1. Disable "Configure Console Redirection" in UEFI Setup by following below steps: - Go to F1 Setup ->
System Settings -> Devices and I/O Ports-> Console Redirection Settings -> - Select "Console
Redirection" - Change the setting to "Disable" and save - Next reboot the system.
2. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
3. If the problem persists, please contact technical support.
Service Action:
1. Review PD Steps.
2. If problem persists, escalate to next level of support
• FQXPMEM0008M: Diagnostic image cannot be launched as the image may be corrupt
Severity: Error
User Action:
1. Restart BMC via supported method and reboot the system.
2. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
3. Reflash the LXPM.
4. If the problem persists, please contact technical support.
Service Action:
1. Review PD Steps.
2. Load the XCC settings to defaults.
3. Reflash XCC firmware.
4. If problem persists, escalate to next level of support
• FQXPMER0002I: Clearing RAID configuration and internal storage
Severity: Info
User Action:
Information only; no action is required.
Service Action:
n/a
• FQXPMER0002M: Failed to clear RAID configuration
Severity: Error
User Action:
1. Restart the system and retry the operation again.
2. If the problem persists, contact technical support.
252
ThinkSystem SR850 V2 System Events Service Guide