Start Installer - ABB OmniCore Operating Manual

10 Install, update, restart, and other configuration

10.2 Start installer

10.2 Start installer
Overview
The start installer option is used to install a system using the installation package.
Procedure
Use the following procedure to install the installation package:
Updating the applications
If the installed system has updates for the applications, you can update the
applications.
Use the following procedure to update the applications:
202
1 On the start screen, tap Settings, and then select Backup & Recovery from
the menu.
2 On the left sidebar tap RobotWare Installation Utilities.
3 Tap Start Installer.
A confirmation message is displayed.
4 Tap OK.
The controller is restarted and the RobotWare Installation Utilities window
is displayed.
5 Tap Install RobotWare System and select the installation package folder.
The selected installation package is added.
6 Tap Start RobotWare System.
7 Tap Start.
The controller is restarted and the system is installed.
1 On the start screen, tap Settings, and then select Update from the menu.
2 If there are updates, a file is displayed in the Available Updates section.
3 Tap Update All.
The applications are updated and the FlexPendant is restarted.
© Copyright 20192020 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: D