Setting Signals As Favorite Signals - ABB OmniCore Operating Manual

8.3 Setting signals as favorite signals

Overview
You can set few signals from various signal categories as favorite signals if you
use it frequently.
Procedure
Use the following procedure to set signals as favorite signals:
Operating manual - OmniCore
3HAC065036-001 Revision: D
1 On the start screen, tap I/O, and then select Favorite Signals from the menu.
2 The Favorite Signals page is displayed and it displays all the signals.
Note
You can use the Filter list to display a selected category of signals.
3 Use the check box to select the signals that need to be set as favorite signals.
4 Tap Apply.
The selected signals are saved as favorite signals.
Tip
The favorite signals are listed under the Favorite Signals category on the Signals
page. To view a selected category of signals, use the procedure
lists on page 192.
© Copyright 20192020 ABB. All rights reserved.
8 Handling inputs and outputs, I/O
8.3 Setting signals as favorite signals
Viewing signal
193