Changing Date And Time - ABB OmniCore Operating Manual

2 Navigating and handling the FlexPendant

2.3.1.3 Changing date and time

2.3.1.3 Changing date and time
Date and time settings
You can configure the date and time settings.
Use the following procedure to configure the date and time.
36
1 On the start screen, tap Settings.
2 Tap Time & Language.
3 On the left sidebar tap Date & Time.
4 Select Network Time or Manual Time.
• Network Time: Select this for configuring the robot controller for
automatic time synchronization using the NTP protocol of a time server.
The time server is identified by its IP address or DNS name.
• Manual Time: Select this if you do not have a time server that is
reachable from the controller.
5 If you select Network Time, in the Time Server Address field type the URL
or IP address of the time server.
Note
Tap the Test button next to the Time Server Address field to verify the
time server address.
6 If you select Manual Time, in the Select date and Select time fields manually
configure date and time.
7 Tap Apply.
The selected settings are saved.
© Copyright 20192020 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: D