Restart - ABB OmniCore Operating Manual

10.3 Restart

Restart controller and FlexPendant
ABB robot systems are designed to operate unattended for long times. There is
no need to periodically restart functioning systems.
Restart the robot system when:
Procedure
Use the following procedure to restart the controller or FlexPendant:
Operating manual - OmniCore
3HAC065036-001 Revision: D
10 Install, update, restart, and other configuration
• new hardware has been installed.
• the robot system configuration files have been changed.
• a new system has been added and is to be used.
• a system failure (SYSFAIL) has occurred.
1 On the start screen, tap Settings, and then select Backup & Recovery from
the menu.
2 On the sidebar tap Restart.
The Restart page is displayed.
3 Select the Controller or FlexPendant check boxes.
4 Tap Restart.
The selected device is restarted.
Note
You can restart the controller or only the FlexPendant for restart. When
the controller is restarted the FlexPendant is restarted automatically .
© Copyright 20192020 ABB. All rights reserved.
10.3 Restart
203