Table of Contents
Advertisement
C
7
HAPTER
FIGURE 2. Product Controller
2. Using a 1/4" driver, remove the two electrical connectors of the Product Control Harness (Raven P/N 115-7300-
093) from the node.
3. Locate the green 12-pin Deustch connection of the Product Control Harness and follow it to the mating cable.
4. Disconnect all connections of the mating cable.
5. Remove the mating cable. This is not needed for the Hawkeye installation.
6. Disconnect the Product Control cable harness from all other connections.
7. Remove the Product Control Cable. This is not needed for the Hawkeye installation.
8. Remove the Multi-Product Node from the machine and set it aside. This is not needed for the Hawkeye
installation.
PRODUCT CONTROLLER II INSTALLATION
BEST PRACTICES AND RECOMMENDATIONS
• Do not connect battery leads until all cables are installed and connected.
• If a protected mounting location is not available on the equipment, mount the Hawkeye product controller II
ECU with the connectors facing down toward the ground to help keep moisture from accumulating in the ECU.
MAGNET MOUNTING ASSEMBLY
1. Locate the magnets and hardware included in the kit (P/N 418-0000-013).
2. Attach the magnets to two mounting holes located diagonally from each other.
26
Product
Controller
Hagie Hawkeye® Installation Manual
Advertisement
Table of Contents
