Warning messages
If the following messages appear, follow
the instructions.
For "InfoLITHIUM" battery only
An incompatible battery pack is being
•
used.
Battery exhausted
The battery pack is discharged. Charge
•
the battery pack.
Set date and time?
Set the date and time. If the message
•
appears frequently, the internal backup
battery is used up. Replace the battery
(pages 156, 169).
Power insufficient
You tried to perform [Cleaning mode]
•
when the battery level is insufficient.
Charge the battery pack or use the AC
Adaptor/charger (not supplied).
No Memory Stick
No CF card
The type of the memory card inserted
•
into the camera is different from the
memory card type selected with
[Memory card] in the
Set it to appropriate position.
Unable to use Memory Stick.
Format?
Unable to use CF card. Format?
The memory card was formatted on a
•
computer and the file format was
modified, or the memory card was
formatted on another device.
Select [OK], then format the memory
card. You can use the memory card
again, however, all previous data in the
memory card is erased. It may take a
some time to complete the format.
If the message still appears, change the
memory card.
158
Card error
Read only memory
Reinsert the Memory Stick.
Reinsert the CF card.
Use Memory Stick slot to format.
Processing...
Setup menu.
No Memory Stick inserted. Shutter is
locked.
No CF card inserted. Shutter is
locked.
An incompatible memory card is
•
inserted or the format was failed.
Your camera cannot record or delete
•
images on this "Memory Stick Duo".
The inserted memory card cannot be
•
used in your camera.
The memory card is damaged.
•
The terminal section of the memory
•
card is dirty.
You attempt to format the "Memory
•
Stick Duo" that is inserted into the CF
card insertion slot using an adaptor.
Insert the "Memory Stick Duo" into the
"Memory Stick Duo" insertion slot and
format it.
When Long exposure noise reduction
•
will be done for the same amount of
time that the shutter was open. You
cannot do any further shooting during
this reduction.
[Release w/oCard] is set to [Disable].
•
Set it to [Enable] or insert a memory
card.