Error/Warning Messages - Sony BURANO MPC-2610 Operating Instructions Manual

118
7. Appendix

Error/Warning Messages

If a warning, caution, or operating condition that requires confirmation occurs on the unit, a
message is displayed on the LCD monitor, the recording/tally lamp starts flashing, and a warning
sound is emitted.
The warning sound is emitted from the headphones connected to the headphone connector.
Error Messages
The unit will stop operation when the following kind of display occurs.
LCD monitor error Warning
display sound
E + error code Continuous
Warning Messages
Follow the instructions provided if the following display occurs.
LCD monitor warning Warning
display sound
Battery Near End Intermittent Flashing
Battery End Continuous
Temperature High Intermittent Flashing
Media Temperature Intermittent Flashing
High
Recording/ Cause and Solution
tally lamp
High-speed The unit may be defective.
flashing Turn off the unit, and check for any problem with
connected devices, cables, or media. If the error
persists when the unit is turned on again, contact
your Sony service representative.
(If power cannot be turned off by setting the
power switch to the  (Standby) position, remove
the battery pack or the DC IN source.)
An error display or warning sound may not occur
depending on the status of the unit.
Recording/ Cause and Solution
tally lamp
The remaining capacity of the battery pack is
getting low.
Recharge at the earliest convenience.
High-speed The battery pack is dead. Recording is disabled.
flashing Stop operation and replace the battery pack.
The internal temperature is high.
Turn off the unit and allow it to cool down before
operating it again.
The temperature of the CFexpress card is high.
Replace the card or allow it to cool down before
using it again.
LCD monitor warning Warning Recording/
display sound tally lamp
Voltage Low Intermittent Flashing
Insufficient Voltage Continuous High-speed
flashing
Media Near Full Intermittent Flashing
Media Full Continuous High-speed
flashing
Clips Near Full Intermittent Flashing
Clips Full Continuous High-speed
flashing
Last Clip Recording Intermittent Flashing
Media(A) 1) Life Near Intermittent Flashing
End
Media(A) 1) Life End Continuous High-speed
flashing
Media(A) 1) Near Full Intermittent Flashing
Media(A) Full Continuous High-speed
1)
flashing
Media(A) Clips Near Intermittent Flashing
1)
Full
Media(A) Clips Full Continuous High-speed
1)
flashing
Media(A) 1) Last Clip Intermittent Flashing
Rec
Transfer Jobs Near – –
Full
Cause and Solution
The DC IN voltage is low (level 1). Check the power
source.
The DC IN voltage is too low (level 2). Recording is
disabled.
Connect a different power source.
The remaining capacity on the memory card is
getting low.
Replace at the earliest convenience.
Clips could not be recorded or copied because
there is no remaining capacity on the memory
card.
Replace immediately.
The number of additional clips that can be
recorded on a memory card is getting low.
Replace at the earliest convenience.
The maximum number of clips that can be
recorded on the memory card has been reached.
Recording or copying more clips is not possible.
Replace immediately.
The clip currently recording is the last clip that can
be recorded, as the maximum number of clips has
been reached.
Prepare a new memory card.
The memory card is approaching the end of its
life. Replace at the earliest convenience.
The memory card has reached the end of its life.
Replace immediately.
When using the Simul Rec function
When using the Simul Rec function
When using the Simul Rec function
When using the Simul Rec function
When using the Simul Rec function
The number of FTP file transfer jobs that can be
registered is getting low.