No lens attached. Shutter is locked.
[Release w/oLens] is set to [Disable].
•
Attach a lens. When attaching the
camera to an astronomical telescope or
something similar, set it to [Enable] in
the
Custom menu.
Unable to display.
Images recorded with other cameras or
•
images modified with a computer may
not be able to be displayed.
No images
There is no image in the memory card.
•
Image protected
You tried to delete protected images.
•
Release the protection.
Unable to print.
You tried to mark RAW images with a
•
DPOF mark.
Initializing USB connection...
A USB connection has been
•
established. Do not disconnect the USB
cable.
Check the connected device.
A PictBridge connection cannot be
•
established. Disconnect the USB cable
and connect it again.
Camera overheating. Allow it to cool.
The camera has become hot because
•
you have been shooting continuously.
Turn the power off. Cool the camera
and wait until the camera is ready to
shoot again.
Camera error
System error
Turn the power off, remove the battery
•
pack, then re-insert it. If the message
appears frequently, consult your Sony
dealer or local authorized Sony service
facility.
Cover open
Close the memory card cover to start
•
shooting.
Check that the access lamp is not lit,
•
then open the cover when you replace
the memory card.
Unable to magnify.
Unable to rotate image.
Images recorded with other cameras
•
may not be enlarged or rotated.
No images changed
You attempted to protect images or
•
specified DPOF without changing the
specification of those images.
Cannot create more folders.
The folder with a name beginning with
•
"999" exists on the memory card. You
cannot create any folders if this is the
case.
Printing canceled
The print job was canceled. Disconnect
•
the USB cable or turn the camera off.
Unable to mark.
You attempted to mark RAW images on
•
the PictBridge screen.
No printable image
You attempted to print images from a
•
folder that has no images when [Folder
print] was selected.
159
Need help?
Do you have a question about the DSLR-A700H Users Guide and is the answer not in the manual?