Setup menu 1
Setup menu
The default settings are marked with
LCD brightness
You can adjust the brightness of the LCD monitor.
1 Select [LCD brightness], then press the center of the multi-selector.
2 Adjust the brightness with b/B on the multi-selector, then press the center of the multi-selector.
• On the recording information or playback screen, you can adjust the brightness by pressing the DISP
(Display) button a little longer.
Info.disp.time
During shooting, the recording information display appears on the LCD monitor. You can
change the displayed time of the display.
1 min
30 sec
10 sec
5 sec
• The display appears again if you press the shutter button halfway down or perform some other operation.
Power save
If you do not operate the camera for given period of time, the camera turns to power saving
mode and almost completely shuts down (Power Save).
You can set the time to turn the camera to the power save mode.
30 min
10 min
5 min
3 min
1 min
• Pressing the shutter button halfway down returns the camera to the recording mode.
120
For details on the operation
.
Displays for one minute.
Displays for 30 seconds.
Displays for 10 seconds.
Displays for five seconds.
The camera turns to power save mode after 30 minutes.
The camera turns to power save mode after 10 minutes.
The camera turns to power save mode after five minutes.
The camera turns to power save mode after three minutes.
The camera turns to power save mode after one minute.
step 4 in "Read This First"
t
1
page 32