Log Into The Ap-3 Unit Using Telnet - Avaya AP-3 User Manual

Avaya ap-3 access point: user guide

Hide thumbs Also See for AP-3:

Table of Contents

Configuring the AP-3 Unit using CLI commands

Log Into the AP-3 Unit using Telnet

The CLI commands can be used to access, configure, and manage your

AP-3 device using Telnet or a terminal emulation application, such as

HyperTerminal. Log into the AP-3 unit using Telnet:

1. Go to the DOS command prompt on your computer.

2. Type in telnet <IP Address of the unit>.

3. Enter the CLI password (default is public).

Note: It is recommended that you change your default passwords

immediately. To perform this operation using CLI commands,

refer to Change Passwords.

Avaya Wireless AP-3 User's Guide