Reset to Factory Default Procedure
Use this procedure to reset the network configuration values, including
the AP-3 IP Address, IP Mask, and so on. The current AP Image is not
deleted. This procedure may be required if the AP-3 password is
forgotten.
1. Press and hold the RELOAD button for about 10 seconds. Result:
The AP-3 reboots, and the factory default network values are
restored.
2. If not using DHCP, use the ScanTool or normal CLI to set the AP-3
IP Address, IP Mask, and so on. Please refer to
Line Interface
Forced Reload Procedure
Use this procedure to erase the current AP image and download a new AP
Image. This procedure may be required when the current AP Image is
missing or corrupted. Note that this does not delete the AP-3's
configuration (in other words, the Forced Reload Procedure does not reset
to device to factory defaults).
In this procedure, use the Bootloader CLI over the serial port to set the IP
Address and download a new AP Image.
1. While the AP Image is running, press the RESET button. Result: The
AP-3 reboots and the indicators begin to flash.
Avaya Wireless AP-3 User's Guide
for CLI information.
Recovery Procedures
Using the Command
5-17