Ap-3 Has Incorrect Ip Address - Avaya AP-3 User Manual

Symptoms and Solutions

AP-3 Has Incorrect IP Address

1. Default IP Address Assignment mode is dynamic (DHCP). If you do
not have a DHCP server on your network, the default IP Address is
10.0.0.1.
2. If the DHCP server in your network is not available for some reason
while the AP-3 unit reboots, the device will retain the last IP Address
it had. Reboot the AP-3 device once your DHCP server is on-line
again or use the ScanTool to find the current IP Address of the AP-3
unit in question.
3. To find the current IP Address using DHCP, check the IP Client
Table in the DHCP Server to find the current AP-3 IP Address, match
to the AP-3 MAC Address in the table to the one on your unit.
4. Or use ScanTool to locate the current AP-3 IP Address. Once you
have the current IP Address, use the HTTP or CLI Interface to either
set the unit to DHCP mode or assign a static IP Address.
5. If you use static IP Address assignments, and cannot access the unit
over Ethernet, use the Initializing the IP Address using Normal CLI
procedure. Once the IP Address is set, you can use the Ethernet
Interface to complete configuration.
6. Perform the Reset to Factory Default Procedure in this guide. This
will reset the unit to "DHCP" mode. If there is a DHCP Server on the
same subnet, the DHCP Server will assign an IP Address to the AP-3.
5-8 Avaya Wireless AP-3 User's Guide