Setting Ip Address Using Serial Port And Normal Cli; Hardware And Software Requirements; Attaching The Serial Port Cable - Avaya AP-3 User Manual

the AP-3 is ready for configuration, providing the AP-3 IP Address
is correct.
7. Once the AP-3 image is downloaded and you have a valid AP-3 IP
Address, configure the AP-3 as described in Prerequisites.

Setting IP Address using Serial Port and Normal CLI

Use the following procedure to set an IP Address over the serial port
using the normal CLI. The network administrator typically provides the
AP-3 IP Address.

Hardware and Software Requirements

• Standard serial data (RS-232) cable with a female DB-9 connector
at each end or a standard serial cable and the Mini-DIN8 to DB-9
adapter included in your kit.
• ASCII Terminal software, such as HyperTerminal.

Attaching the Serial Port Cable

1. Remove power from the AP-3 and your computer.
2. Connect the serial port cable to the back of the AP-3 unit and to your
computer.
3. Restart the computer and power up the Access Point device.
Avaya Wireless AP-3 User's Guide
Recovery Procedures
5-21