Log Into The Ap Using Telnet - Avaya Wireless AP-3 User Manual

Log into the AP using Telnet

The CLI commands can be used to access, configure, and manage the
AP using Telnet. Follow these steps:
1. Confirm that your computer's IP address is in the same IP subnet
as the AP.
NOTE:
If you have not previously configured the Access Point's IP address
and do not have a DHCP server on the network, the Access Point
will default to an IP address of 10.0.0.1.
2. Go to the DOS command prompt on your computer.
3. Type telnet <IP Address of the unit>.
4. Enter the CLI password (default is public).
NOTE:
Avaya recommends changing your default passwords immediately.
To perform this operation using CLI commands, refer to
Passwords.
Avaya Wireless AP-3 User's Guide
Configuring the AP using CLI commands
Change
A-37