Table of Contents
Advertisement
The MITX-CFL0 Series meets the following standards and certification tests.
Table 3: Standards and Certifications
CE Class A
FCC Class A
3.5. Processor Support
The MITX-CFL0 Series is designed to support the following processors which are connected to a discrete Intel® Q370
or H310 Chipset Platform Controller Hub on the motherboard.
9th Generation Intel® Core™ S-Series (FCLGA1151 socket, up to 65 W TDP)
8th Generation Intel® Core™ S-Series (FCLGA1151 socket, up to 65 W TDP)
Intel® Celeron® G4900 Series (FCLGA1151 socket, up to 65 W TDP)
Sufficient cooling must be applied to the APU in order to remove the effect defined as TDP (Thermal Design Power).
The sufficient cooling is also depending on the worst case maximum ambient operating temperature and the actual
worst case load of processor.
3.6. System Memory Support
The MITX-CFL0 Series has two DDR4 SO-DIMM sockets. The sockets support the following memory features:
2x DDR4 SO-DIMM, 1.2 V
Up to 32 GB (2x 16 GB)
Dual channel, 260-pin, 2666 MT/s (Core™ i9 / i7 / i5) or 2400 MT/s (Core™ i3 / Celeron®)
SPD timing supported
ECC not supported
The installed DDR4 SO-DIMM should support the Serial Presence Detect (SPD) data structure. This allows the BIOS to
read and configure the memory controller for optimal performance. If non-SPD memory is used, the BIOS will attempt
to configure the memory settings, but performance and reliability may be impacted, or the board may not be able to
boot totally.
3.6.1. Memory Operating Frequencies
In all modes, the frequency of system memory is the lowest frequency of all the memory modules placed in the
system. Each memory module's frequency can be determined through the SPD registers on the memory modules.
The table below lists the resulting operating memory frequencies based on the combination of SO-DIMMs and
processor.
www.kontron.com
TBD
TBD
MITX-CFL0 Series - User Guide, Rev. 1.1
// 20
Advertisement
Table of Contents
