Accessories; Accessories And Connections - Kohler APM402 Operation

6.1 Accessories and Connections

Several accessories help finalize installation, add convenience to operation and service, and establish state and local code
compliance.
Accessories vary with each generator set model and controller. Select factory-installed and/or shipped-loose accessories.
See Figure 58 for a list of available kits. Obtain the most current accessory information from your local authorized service
distributor/dealer.
This section illustrates several accessories available at print time of this publication. Accessory kits generally include installation
instructions. See wiring diagrams manual for electrical connections not shown in this section. See the installation instructions
and drawings supplied with kit for information on kit mounting location.
The instructions provided with the accessory kit supersede these instructions where there are differences. In general, run AC
and DC wiring in separate conduit. Use shielded cable for all analog inputs. Observe all applicable national, state, and local
electrical codes during accessory installation.
See the section titled: Accessory Connections for terminal identification.
Kit Description
Battery Charger (with alarms)
Common Fault/Failure (32A) Connections
Fifteen-Relay Dry Contact Board with NO and NC Contacts
Gas Fuel Valve
Input/Output Module Board
Key Switch
Low Fuel (Level) Switch
Low Fuel (Pressure) Switch
Manual Speed Adjust
Prime Power Switch
Remote Emergency Stop
Remote Reset Feature
Remote Serial Annunciator
Run Relay
Shunt-Trip Line Circuit Breaker
Figure 58 Optional Accessories
TP-6694 9/20
Section 6. Accessories
129