Kohler APM402 Operation page 165

Description
Voltage regulator, volts
per Hertz slope
Voltage regulator, volts
per Hertz cutin
frequency
* Some functions require optional input sensors or are engine ECM dependent on some generator set models.
# ECM inputs are engine manufacturer dependent.
] Changeable only by resetting the controller with a personality profile (SiteTech 1.4 or higher).
** Denotes the default parameter range. Typically, ranges for the NiCad battery topology are slightly wider. For more details, refer to the
battery charger operation manual.
ST- Short Term, LT- Long Term
TP-6694 9/20
Write
Controller Access
Display Display Running
Message
SiteTech Stopped
S
S
GenSet
Mode
Always
Range Default
Setting Selection
R 1-10
R 42-62
Time Default
Delay Time
Range Delay
(sec.) (sec.)
5
57.5
Programmer-
Defined
Settings
165