ECM
Powered
Figure 20
ECM Powered Display
2.
After several seconds, the display will change to provide the option to power down the controller. See Figure 21.
ECM powered
Push to Stop
Figure 21
ECM Power Down Display
3.
If desired, press the selector dial to power down the engine ECM.
OR
Rotate the selector dial to navigate to any of the available menus.
Procedure for Powering Up the Engine ECM using SiteTech™ (for Decision-Maker
Versions Before 3.10)
Connect a PC with SiteTech™ software to the generator set controller. Refer to the SiteTech™ Software Operation Manual
TP-6701 as needed.
Follow the instructions shown in Figure 22.
Locate Genset System Configuration-
ECM Power in SiteTech™
SiteTech™ Software Display Screen
Figure 22
56
®
3000 controllers with Firmware
Click drop down arrow and select True to
power up the engine ECM
TP-6694
SB-724
9/20