Kohler APM402 Operation page 40

Description
Charger Voltage Absorption (V)
Charger Voltage Bulk (V)
Charger Voltage Equalize (V)
Note:
Equalize is only available with
FLA/VRLA topology selected.
Charger Voltage Float (V)
Current transformer ratio ‡
ECM power
Engine cooldown delay
Engine (cyclic) crank on
Engine (cyclic) crank pause
Engine ECM start delay
Engine idle duration
Engine no. of (cyclic) crank
cycles
Engine restart delay
Engine start aid delay
Engine start delay
Equalize Current Limit (A)
Note:
Equalize is only available with
FLA/VRLA topology selected.
Forced Charge Cycle Reset
Output Enable
System battery voltage ‡
Voltage regulator gain
Voltage regulator stability
adjust
Voltage regulator, volts per
Hertz slope
Voltage regulator, volts per
Hertz cut in frequency
* Function requires optional input sensors or is engine ECM dependent on some generator set models.
† ECM inputs are engine-manufacturer dependent.
‡ Changeable only by resetting the controller with a personality profile (SiteTech 1.4 or higher).
** Denotes the default parameter range. Typically, ranges for the NiCad battery topology are slightly wider. For more details, refer to the
battery charger operation manual.
ST- Short Term, LT- Long Term
40
Fault
Controller Lamp
Display Alarm Warning
Message Horn Shutdown
GenSet
Write Mode
Access
Always
Display Running Range
SiteTech Stopped Setting
13–15
(12 V)**
S A
26–30
(24 V)**
13–15
(12 V)**
S A
26–30
(24 V)**
14–16
(12 V)
A
28–32
(24 V)
13–14
(12 V)**
S A
26–28
(24 V)**
S S 1-
S S 0-1
S A
S A
S A
S A
S A
S S 1-6
S A
S A
S A
S A 1–5
Active
S A
Inactive
Fixed
S S 12-24
S R 1-255
S R 1-255
S R 1-10
S R 42-62
Time Default
Delay Time
Default Range Delay
Selection (sec.) (sec.)
14.25
(12 V)
28.5
(24 V)
14.25
(12 V)
28.5
(24 V)
13.25
(12 V)
26.5
(24 V)
1200
0
0-600 300
10-30 15
1-60 15
0-300 0
0-60 60
3
1-10 10
0-10 0
0-300 0
Inactive
Active
12
128
128
5
57.5
TP-6694 9/20