Self-Diagnostic Error Codes - NAiS FP Series Hardware Manual

Self-Diagnostic and Troubleshooting
Error Name of error
code
E8 Operand error
(OPR COMBI)
11.3.3

Self-Diagnostic Error Codes

Error Name of error
code
E31 Interrupt error 1
E32 Interrupt error 2
E45 Operation error
E100 Self-diagnostic
to error set by
E199 F148 (ERR) F148 (ERR)
instruction
E200
to
E299
11-12
Operation
Description and steps to take
status
Stops There is an incorrect operand in an instruction which requires a
specific combination operands (for example, the operands must all be
of a certain type).
Enter the correct combination of operands.
Operation
Description and steps to take
status
Stops An interrupt occurred without an interrupt request.
A hardware problem or error due to noise is possible.
Turn OFF the power and check the noise conditions.
Stops An interrupt occurred without an interrupt request.
A hardware problem or error due to noise is possible.
Turn OFF the power and check the noise conditions.
There is no interrupt program for an interrupt which occurred.
Check the number of the interrupt program and change it to agree
with the interrupt request.
Selects Operation became impossible during a high-level instruction. The
cause of the operation error varies depending on the instruction. In
system register 26, select "1: Continue operation" or "0: Stop"
Stops The error set using high-level instruction F148(ERR) has occurred.
Clear the error based on the set detection conditions
Continues
Matsushita Electric Works (Europe) AG
FP0 Hardware