NAiS FP Series Hardware Manual page 169

System Registers
Address
RS232C 412
port
setting
413
414
415
416
417
RS232C 418
port
setting
A-14
Name of system register
Communication method
setting for RS232C port
Communication format setting
for RS232C port
Setting item/Default setting
value
– Start code: None
– Terminal code: CR
– Stop bit: 1 bit
– Parity check: With odd
– Data length: 8 bits
Baud rate Setting by
setting for FPWIN Pro
RS232C port or NPST–GR
ver. 4
Unit number setting for
RS232C port (when
connecting C–NET)
Modem compatibility setting
for RS232C port
Starting address setting for
reception buffer
Capacity C10C/ C14C/
setting for C16C type
reception
C32C/ T32CP
buffer
type
Default
Set value (parameter)
value
K0 Using FPWIN Pro or NPST–GR, select
items from the menu.
Using FP programmer II:
K0: RS232C port is not used.
K1: Computer link mode (when connecting
C–NET)
K2: Serial data communication mode (gener-
al port)
H3 Using FPWIN Pro or NPST–GR, select items
from the menu.
Using FP programmer II:
Specify the setting contents using H
constants.
15
Start code 0: No STX
Terminal code 00: CR
10: None
Stop bit 0: 1 bit
Parity check 00: None
Data length 0: 7 bits
H1 0: 19200 bps
1: 9600 bps
2: 4800 bps
3: 2400 bps
4: 1200 bps
5: 600 bps
6: 300 bps
K1 K1 to K32 (unit No. 1 to 32)
H0 Using FPWIN Pro or NPST–GR, select
items from the menu.
Using FP programmer II.
H0: Modem disabled
H8000: Modem enabled
K0 C10C/C14C/C16C type: K0 to K1660
C32C type: K0 to K6144
K1660 K0 to K1660
K6144 K0 to K6144
Matsushita Electric Works (Europe) AG
FP0 Hardware
6
0
1: STX
01: CR+LF
11: ETX
1: 2 bits
01: With odd
11: With even
1: 8 bits