Table Of Mewtocol Command; Mewtocol-Com Commands; Table Of Mewtocol-Com Error Code - NAiS FP2 Technical Manual

7.4 Table of MEWTOC OL Command
The following is a table of MEWTOCOL commands that can be used with the FP2 Multi Communication
Unit (MCU).
7.4.1

MEWTOCOL-COM Commands

RCS Read single point of contact information
WCS Write single point of contact information
RCP Read plural points of contact information
WCP Write plural points of contact information
RCC Read word unit of contact information
WCC Write word unit of contact information
SC Preset word unit in contact area
RD Read data area
WD Write data area
SD Preset of data area
RS Read timer and counter set value area
WS Write timer and counter set value area
RK Read timer and counter elapsed value area
WK Write timer and counter elapsed value area
MC Registration and reset of monitor contact
MD Registration and rest of monitor data
MG Monitor execution
RR Read system register
WR Write system register
RT Read PLC status
RM Remote control (RUN/PROGRAM mode switching)
AB Transmission abort command
7.4.2

Table of MEWTOCOL-COM Error code

40 BCC error
41 Format error
42 NOT support error
43 Multi frame process error
53 Busy error
60 Parameter error
61 Data error
62 Registration over error
63 PC mode error
65 Protect error
66 Address error
67 Missing program
error/Missing data error
7-12
Transmission error occurred in received data.
Command that does not match the format was received.
An unsupported command was received.
Another command was received during the processing of multi-
frame.
Command process can not be received due to the processing of
multi-frame, or as the command during processing is busy.
Specified parameter does not exist, or cannot be used.
There is an error in the contact, data area, data number, size,
range or format specification.
Number of registration exceeded the restriction, or operation is
performed without registration.
Invalid command was executed in RUN mode.
Write operation was performed to the program area or system
register in the protect (such as password setting or dip SW)
mode or ROM operation mode.
There is an error in the specified address data.
Program cannot be read as there is no program in program area
or an error in memory contents. Or unregistered program was
read.