NAiS FP Series Hardware Manual page 138

FP0 Hardware
2. Insert wire into the RS232C port until it contacts the back of
the RS232C port.
3. Tighten the screw clockwise to fix the wire in place.
Notes
When removing the wire's insulation, be careful not to scratch
the core wire.
Do not twist the wires to connect them.
Do not solder the wires to connect them. The solder may
break due to vibration.
After wiring, make sure stress is not applied to the wire.
In the RS232C port terminal construction, if the wire closes
upon counter-clockwise rotation, the connection is faulty.
Disconnect the wire, check the terminal hole, and then
re-connect the wire.
Matsushita Electric Works (Europe) AG
Clockwise
Clockwise
CORRECT
Wire
9.8
RS232C port
Suitable wire
Counter
clockwise
Wire
INCORRECT
Wiring the RS232C Port
9-17