NAiS FP Series Hardware Manual page 176

FP0 Hardware
Addresses
T32CP Other Types
DT90022 DT9022
DT90023 DT9023
DT90024 DT9024
DT90025 DT9025
DT90026
DT9026
DT90027 DT9027
DT90028 DT9028
DT90029 DT9029
DT90030 DT9030
(* see note
2)
DT90031 DT9031
(* see note
2)
DT90032 DT9032
(* see note
2)
DT90033 DT9033
(* see note
2)
DT90034 DT9034
(* see note
2)
DT90035 DT9035
(* see note
2)
DT90036 DT9036
DT90037 DT9037
Matsushita Electric Works (Europe) AG
Description
Scan time (current value)
The current scan time is stored here. Scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) × 0.1
K50 indicates 5 ms.
Scan time (minimum value)
The minimum scan time is stored here. Scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) × 0.1
K50 indicates 5 ms.
Scan time (maximum value)
The maximum scan time is stored here. Scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) × 0.1
K125 indicates 12.5 ms.
Mask condition monitoring register for interrupts(INT 0 to 5)
The mask conditions of interrupts using ICTL instruction can be moni-
tored here. Monitor using binary display.
15 11 7 3
23 19
0: interrupt disabled (masked)
1: interrupt enabled (unmasked)
Not used
Periodical interrupt interval (INT 24)
The value set by ICTL instruction is stored.
– K0: periodical interrupt is not used
– K1 to K3000: 10 ms to 30 s
Not used
Not used
Message 0
Message 1
Message 2
Message 3
Message 4
Message 5
The contents of the specified message are stored in these special data registers The contents of the specified message are stored in these special data registers
when an F149 (MSG) instruction is executed.
Not used
Work 1 for F96 (SRC) instruction
The number of data that match the searched data is stored here when an F96 (SRC)
instruction is executed.
C.1 Special Data Registers
(* see note 1)
(* see note 1)
(* see note 1)
0 (Bit No.)
16 (INT No.)
C-3