NAiS FP Series Hardware Manual page 168

FP0 Hardware
[High–speed counter] –> [Pulse catch] –> [Interrupt input].
When the high–speed counter is being used in the incremental
input mode, even if input X0 is specified as an interrupt input
and as pulse catch input, those settings are invalid, and input
X0 functions as counter input for the high–speed counter.
No. 400: H1 <– This setting will be valid.
No. 402: H1
No. 403: H1
Address
Tool port 410
setting
411
414
Tool port/ 414
RS232C
port
setting
Matsushita Electric Works (Europe) AG
Name of system register
Unit number setting for tool
port (when connecting
C–NET)
Communication format
setting for tool port
Setting item
S Default setting value
S Modem communication:
Disabled
S Data length (character bits):
8 bits
Baud rate Setting by
setting for tool FPWIN Pro
port or NPST–GR
ver. 4
Baud rate Setting by
setting for tool FP
port and programmer
RS232C port II
A.2
Default
Set value (parameter)
value
K1 K1 to K32 (Unit No. 1 to 32)
H0 Using FPWIN Pro or NPST–GR
Select items from the menu.
Using FP programmer II
Specify the setting contents using H
constants.
15
Modem communication
0: Disabled
1: Enabled
Data length
(character bits)
0: 8 bits
1: 7 bits
When connecting a modem, set the unit num-
ber to 1 with system resister 410.
H0 0: 9600 bps
1: 19200 bps
H1
H 0 0
Tool port
H0: 9600 bps
H1: 19200 bps
If anything other
than H0 or H1 is set
for the tool port baud
rate, the baud rate
will be 9600 bps.
If 19,200 bps is set for both the tool port and
RS232C port
–> H100 should be written.
Tables of System Registers
6
0
RS232C port
H0: 19200 bps
H1: 9600 bps
H2: 4800 bps
H3: 2400 bps
H4: 1200 bps
H5: 600 bps
H6: 300 bps
A-13