Det-Tronics X Series Instructions Manual page 9

Device Status Options
Normal
Quick Alarm
UV Pre-Alarm
UV Alarm
Manual UV Active
Auto UV Active
UV o i Cal Active
Warm-Up
Fire Alarm
IR Pre-Alarm
IR Alarm
Man IR Active
Auto IR Active
IR o i Cal Active
0-20 Value
Faults
Fire Relay
Fault Relay
Aux. Relay
UV Counts Per Second
IR Energy
Note: All information displayed on this window is read only. X5200 window shown. X9800 and X2200 use the same with with the appropriate fields and indicators active.
3.1
Description
Power is applied and no faults are occurring.
Quick fire alarm signal generated.
UV sensor in pre-alarm condition.
UV sensor generating fire alarm signal.
Manual o i test on UV sensor in progress.
Automatic o i test on UV sensor in progress.
o i calibration of UV sensor in progress.
Detector in power-up time delay mode.
A fire condition has been detected (both UV and IR in alarm).
IR sensor in pre-alarm condition.
IR sensor generating fire alarm signal.
Manual o i test on IR sensor in progress.
Automatic o i test on IR sensor in progress.
o i calibration of IR sensor in progress.
Signal level of 4-20 mA output (signal is displayed even if detector has no 4-20 mA output).
Refer to the Troubleshooting section
Fire relay energized.
Fault relay energized.
Auxiliary relay energized.
Indication of how much UV is being detected.
Indication of how much IR is being detected.
Figure 9— X5200, X2200, X9800 Device Status tab
7 95-8751