Replacing Parts - Angelo Po 191FAG Use And Installation Manual

GREASING THE GAS TAP
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
7 - Coat the cone with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to remove the excess grease.
9 - Replace the cone (F) and the cap (E).
10 - Replace the control panel (B) and the knobs (A)
on completion of the operation.
RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
IT
if turned on. If work parts have to be replaced, use
original spare parts only. The manufacturer de-
GB
DE
REPLACING THE TOP BURNER NOZZLE (Ø80 - 4 KW)
To carry out this operation,
FR
proceed as follows.
1 - Turn off the gas supply
tap.
ES
2 - Remove the grid (A).
3 - Extract the burner (B).
4 - Unscrew the nozzle (C)
and replace it with the
one suitable for the type
of gas in use (see table
at back of manual).
5 - Replace the burner and
the grid.
English

REPLACING PARTS

A
- 22 -
C
A C B
clines all responsibly for injury or damage to com-
ponents due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
B
E F
D
IDM-39614602300.tif
9
8
C
IDM-39614602400.tif