Angelo Po 191FAG Use And Installation Manual page 40

To carry out this operation, proceed as follows.
1 - Remove the burner cap (A) and the burner (B).
2 - Clean the burner and the flame cap thoroughly
and check that the holes in it are not blocked.
3 - Clean the ignition slot in the burner regularly.
4 - Clean the hob.
5 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
6 - Dry the surfaces and reassemble the compo-
nents. For correct burner assembly, follow the
instructions shown in the figure.
Caution - warning
Never pour water or allow dirt to fall into the
burner as this will cause the burner to mal-
function or block the nozzle.
To carry out this operation, proceed as fol-
lows.
1 - Remove the bottom plate (C) and the grid
(D) from the oven and clean them thor-
oughly.
2 - Clean the inside parts of the oven to remove
any deposits which may impair its operation.
3 - Dry the surfaces and reassemble the compo-
IT
IT
nents.
GB GB
DE DE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
FR FR
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
ES ES
panel (B).
4 - Undo the screw (D) of the pressure connection.
5 - Connect the pressure gauge (E) to the pressure
test point (F).
6 - Turn the gas supply tap back on.
7 - Light all the burners and turn the knobs to the
full flame setting (see page 9), then check that
the pressure reading complies with the values
provided in the table at the back of the manual.
8 - Turn off the burners, disconnect the pressure
gauge and return all components to their initial
condition on completion of the operation.
English
CLEANING THE HOB, BURNERS AND ACCESSORIES
CLEANING OVEN
CHECKING GAS PRESSURE
D
C
C
A C B
- 12 -
A
B
IDM-39614600900.tif
IDM-39614601000.tif
E
IDM-39614601100.tif
F
D