btsr SMART MATRIX WINDINGFEEDER Operating Manual page 57

Example 1 of parameter setup in the
START METER =
START TENS =
WORK TENS =
INC/DEC METER =
TARGET METER =
TARGET TENS =
Esample 2 of parameter setup in the
START METER =
START TENS =
WORK TENS =
INC/DEC METER =
TARGET METER =
TARGET TENS =
In both examples, the system starts working with the
meters, it continues keeping the
TARGET TENS that will be maintained until the Target signal is reset; at this point, the
resumed.
4 - Tension Profiler Function Enabled with TARGET and
With respect to the previous example, we now introduce a further item
the WORK TENS with the timing established in
This allows you to dynamically change the work tension with constant increment/decrement steps in such a
way as to obtain a package compliant with the specific requirements of the process which the package itself
will be subsequently destined to.
With the introduction of the two variables:
values (START TENS, WORK TENS
Profiles"
Example 1 of parameter setup in the
START METER = 200
START TENS = 10
WORK TENS = 5
INC/DEC METER = 2000
INC/DEC TENS = -0.1
TARGET METER = 50000
TARGET TENS = 2
PROFILE
200
10
5
OFF
50000
2
PROFILE
200
3
5
OFF
50000
2
WORK TENS constant until reaching the Target, then switches to the
INC/DEC
INC/DEC TENS
and TARGET
PROFILE
SMART MATRIX WINDINGFEEDER
window:
window:
START TENS, switches to
INC/DEC METER
(INC/DEC
METER.
and INC/DEC METER, in addition to the 3 typical
TENS) it is possible to obtain a lot of different "Tension
window:
Tension Profiler
WORK TENS after 200
START TENS will be
Activated
TENS) used to graduate
- 45 -