Tension Profiler - btsr SMART MATRIX WINDINGFEEDER Operating Manual

Tension Profiler

Unlike the hosiery and knitting textile machines, etc. which always provide a hardware synchronization
related to the various processing steps, in the yarn preparation machines, the only possible way to obtain a
synchronization is to implement an automatic synchronization through a continuous reading of the amount of
yarn absorbed.
The Smart Matrix Windingfeeder System allows you to adjust in dynamic and predefined way the yarn
tension during the textile machine operation.
This "dynamic and pre-defined" adjustment is called "Tension Profiler" and allows you to obtain several
processing combinations to meet the specific application needs.
The Tension Profiler function can be either enabled or disabled with the
PROFILE window.
When it is disabled (TENSION MODE
depending on the values set in
If, on the contrari, it is enabled
programming the desired tension trend trought all the parameters of
Application Examples Based on Tension Profiler Function
1 - Tension Profiler Function Disabled
You may setup only the following values:
- WORK TENS P1
- WORK TENS P2
- INC/DEC TENS
- TARGET METER
In this case, a constant tension
a different tension value
conditions.
The Target option (if activated) will generate the relevant signaling when reaching the number of meters set.
Example of parameter setup in the
=
WORK TENS P1
=
WORK TENS P2
=
INC/DEC TENS
=
TARGET METER
2 - Tension Profiler Function Enabled
activated
In some applications, it is the textile machine that establishes when the package is completed, therefore the
yarn feeding device is not requested to generate the target output.
However, it could be useful to operate with 2 different tension values:
- In fase di partenza (o ripartenza) della posizione
In fase di lavoro normale
-
= P1/P2), the tension applied to the yarn will keep a constant trend
WORK TENS P1 and if required in
(TENSION MODE
(TENSION MODE
[0.2 to 99.5 g]
[0.2 to 99.5 g or OFF]
– It can be handled with external Inc/Dec commands only.
[1 to 1.000.000 meters or OFF]
(WORK TENS P1) will be applied to the yarn for the entire working cycle and
(WORK TENS P2) will be applied (if activated) during the machine stationary
PROFILE
10
5
0.0
OFF
(TENSION MODE
SMART MATRIX WINDINGFEEDER
TENSION MODE
WORK TENS P2.
= PROFILER), then the user will have the possibilità of
PROFILE
= P1/P2)
window:
= PROFILER) with Target De-
Tension Profiler
parameter within the
window.
- 43 -