Datex-Ohmeda AS/3 Compact Monitor Technical Reference Manual page 64

Datex-Ohmeda AS/3 CM and CS/3 CMC
General
1.
?
2.
?
Anesthesia Keyboard, K-ARK
3.
?
Remote Controller, K-REMCO
4.
?
56
Document No. 896 623
Check the external parts:
−
All the four rubber pads under the monitor are in place.
−
All the stickers are intact.
−
The LCD screen is intact.
−
The ComWheel cover is intact and attached properly.
−
The ON/STBY -switch and it's protector are intact and attached properly.
−
All connectors are clean and intact.
−
The thumb screws for cables on PC boards are intact.
−
The software card slot is covered with a lid (B-CMCPU4).
−
The service reset- switch is intact.
−
The handle is attached properly.
−
The outer cover is intact
Check that modules go in smoothly and lock up properly in all module slots.
Check external parts:
−
the anesthesia keyboard plastic frame is intact
−
the front panel stickers are intact
−
the ComWheel cover is intact and is attached properly
−
all four rubber pads are in place on the bottom cover
Check the anesthesia keyboard interface cable:
−
the cable is intact
−
the cable is connected and locked properly
Check external parts:
−
the remote controller plastic frame is intact
−
the keypad is intact
−
the ComWheel cover is intact and attached properly
−
the screws at the bottom are tightened properly
Check the remote controller interface cable:
−
the cable is intact
−
the cable is connected and locked properly