Setting The Interfacing Parameters; Setting The Interfacing Parameters For The Compact Monitor; Interfacing With Datex-Ohmeda Monitors Via Upinet Board, B-Upinet - Datex-Ohmeda AS/3 Compact Monitor Technical Reference Manual

4.1.2 Setting the Interfacing Parameters

Set the serial output mode of Datex-Ohmeda monitors: Capnomac Ultima, Satlite Trans and
Normocap to numeric. This setting can be stored into permanent memory through the startup
menu. See the monitors' manual for further information.

4.1.3 Setting the Interfacing Parameters for the Compact Monitor

1.
2.
3.
4.

4.2 Interfacing with Datex-Ohmeda Monitors via UPINET Board, B-UPINET

It is possible to interface Datex-Ohmeda monitors to the Compact Monitor via the UPINET Board, B-
UPINET. The parameters transferred to the Compact Monitor are summarized in table 4-1.
NOTE: Because the analog inputs are missing, waveforms are not transferred to the Compact
Monitor if the UPINET Board, B-UPINET is used.
Interconnection
Use the B-INT-External Device Cable to connect the Compact Monitor to Datex- Ohmeda monitors.
1.
2.
3.
Setting the Interfacing Parameters for Datex-Ohmeda Monitors
Set the interfacing parameters for the Datex-Ohmeda monitors according to previously described
procedure.
Setting the Interfacing Parameters for Compact Monitor
Set the interfacing parameters for the Compact Monitor according to previously described
procedure.
Press the Monitor Setup key.
Select Install/Service password (16-4-34).
Select Interfacing and combine a required parameter with an external monitor. Two letters,
al, denote alarm integration. The selection will be automatically stored in permanent
memory.
Press the Normal Screen key.
Make sure that the power is turned off on both devices.
Connect the 9 pin D-shaped connector to the corresponding connector on the UPINET
Board, B-UPINET.
Connect the remaining 25 pin D-shaped connector to the corresponding connector on the
rear of the other monitor. Tighten the finger screws.
General Service Guide
47
Document No. 896 623