Link Ports (P5, P6); Usb (P7); Jtag (P8); Audio (P9, P10) - Analog Devices ADSP-21160 EZ-KIT LITE Manual

4.5.3 Link Ports (P5, P6)

Each link port is connected to a 26-pin connector. Refer to
Devices website for more information about the link port connectors.

Table 4-7: P5, P6 Part Number Information

Part Description
26-Position connector (P5, P6)
Cable Assembly (30 cm)
Cable connector
Shroud
Coaxial cable

4.5.4 USB (P7)

The USB connector is a standard Type B USB receptacle. This connector is used
to debug the DSP, and is not connected to the DSP's USB interface.

Table 4-8: P7 Part Number Information

Part Description
Type B USB receptacle (P7)
USB cable (provided with kit)

4.5.5 JTAG (P8)

The JTAG header is the connecting point for a JTAG in-circuit emulator pod.
When an emulator is connected to the JTAG header, the USB debug interface is
disabled.
! NOTE: Pin 3 is missing to provide keying. Pin 3 in the mating connector
should have a plug.
! NOTE: When using an emulator with the EZ-KIT Lite board, follow the
connection instructions provided with the emulator.

4.5.6 Audio (P9, P10)

There are two 3.5mm stereo audio jacks: one input, and one output.
ADSP-21160 EZ-KIT Lite Evaluation System Manual
Manufacturer
Honda
Mating Connector
ADI
Honda
Honda
Gore
Manufacturer
Mill-Max
Digi-Key
Mating Connector
Assmann
Digi-Key
EE-106 on the Analog
Part Number
RMCA-26JL-AD
ADDS-LPCAB-30
RMCA-E26F1S-A
RMCA-E26L1A
DXN2132
Part Number
897-30-004-90-000
ED90003-ND
AK672-5
AK672-5ND
4-37