Acx5048 Router Hardware And Cli Terminology Mapping - Juniper ACX5048 Hardware Manual

ACX5048 Router Hardware and CLI Terminology Mapping

Table 5 on page 23 describes the hardware terms used in an ACX5048 router documentation and the
corresponding terms used in the Junos OS command line interface (CLI).
port locations of the interfaces.
Table 5: CLI Equivalents of Terms Used in Documentation for an ACX5048 Router
Hardware
Item (as Description (as
displayed displayed in the
in the CLI) CLI)
Chassis ACX5048
FPC (n) Abbreviated name
of the Flexible PIC
Concentrator (FPC)
PIC (n) Abbreviated name
of the Physical
Interface Card (PIC)
48x10G–6x40G
Xcvr (n) Abbreviated name
of the transceiver
Power Power supply
supply (n)
Value (as
displayed in the Item in
CLI) Documentation
– Router chassis
Value of n is always The router does not
0. have actual FPCs. In this
case, FPC refers to the
router itself.
Value of n is always The router does not
0. have actual PIC devices;
see entries for PIC 0 for
the equivalent item on
the router.
PIC 0 Built-in network ports
on the front panel of the
router
n is a value Optical transceivers
equivalent to the
number of the port
in which the
transceiver is
installed.
n is a value in the AC power supply
range of 0-1.
DC power supply
Figure 3 on page 24 shows the
Additional Information
"Chassis Physical Specifications
for an ACX5000 Router" on
page 82
Interface Naming Conventions
Used in the Junos OS
Operational Commands
Interface Naming Conventions
Used in the Junos OS
Operational Commands
"ACX5000 Universal Metro
Router Overview" on page 17
Port and Interface Specifications
"AC Power Supply for an
ACX5000 Router" on page 65
"DC Power Supply for an
ACX5000 Router" on page 69
23