Acx5048 And Acx5096 Management Cable Specifications And Pinouts; Cable Specifications For Console And Management Connections For An Acx5000 Router - Juniper ACX5048 Hardware Manual

For multimode transmission, modal dispersion, rather than chromatic dispersion or attenuation, usually
limits the maximum bit rate and link length. For single-mode transmission, modal dispersion is not a factor.
However, at higher bit rates and over longer distances, chromatic dispersion rather than modal dispersion
limits maximum link length.
An efficient optical data link must have enough light to exceed the minimum power that the receiver
requires to operate within its specifications. In addition, the total dispersion must be less than the limits
specified for the type of link in Telcordia Technologies document GR-253-CORE (Section 4.3) and
International Telecommunications Union (ITU) document G.957.
When chromatic dispersion is at the maximum allowed, its effect can be considered as a power penalty in
the power budget. The optical power budget must allow for the sum of component attenuation, power
penalties (including those from dispersion), and a safety margin for unexpected losses.
ACX5048 and ACX5096 Management Cable
Specifications and Pinouts
IN THIS SECTION

Cable Specifications for Console and Management Connections for an ACX5000 Router | 95

Management Port Connector Pinouts for an ACX5000 Router | 96
Console Port Connector Pinouts for an ACX5000 Router | 97
USB Port Specifications for an ACX5000 Router | 98
Cable Specifications for Console and Management Connections for an
ACX5000 Router
Table 32 on page 96 lists the specifications for the cables that connect the ACX5000 routers to a
management device.
95